3
3.2 Rear Panel
1 EDID Control Jumper: Default factory setting is TV, leave as if the display
is properly. Switch to STD to use build-in EDID if the display has problems.
When the EDID control jumper in TV selection, the unit will detect the first
HDMI output source's EDID and record in the unit. If the first detected
output source is DVI it will pass to next source, until the first HDMI been
detected.
2 RS232: 9-pin D-Sub connector for connecting to your PC or other control
console for remote control.
3 HDMI Inputs 1 and 2: Connect each of the input ports to the HDMI or DVI
output of your source equipment such as DVD player or set-top-box.
4 HDMI Outputs 1 to 10: Connect each of the output ports to the HDMI
display. When more than one output connected, the HDMI outputs play
identical video signal simultaneously.
5 Power: Plug the 5V DC power supply into the this unit and connect the
adaptor to AC wall outlet.
DC 5V
RS-232
1
2
1
2
3
4
5
6
7
8
9
10
EDID
STD TV
HDMI OUT
HDMI IN
1
3
4
5
2
