6. Operation Controls and Functions
6.1 Front Panel
1
2
3
4
5 6
7
HDMI
OUTPUT
HDMI
INPUT
1
STD
TV ON
OFF
EDID SYS. Reset
SYNC
POWER
DC 5V
CLUX-4M HDMI V1.3 Splitter
①
HDMI OUTPUT 1: Connect each of the output ports to an HDMI display.
When more than one output source is connected, an identical video
signal will be shown on the connected displays.
②
HDMI INPUT: Connect the input port with the HDMI or DVI output of your
source such as a DVD/Blu-Ray player or Set Top Box.
③
EDID: The default factory is set to TV, please leave as is when the displays
are working properly. Switch to STD to use the built-in EDID, for more
information see Note.
④
SYS. Reset: The factory default is "OFF". When switched "ON" the system will
send an internal CEC to the display within 8~10 minutes in order to force
all the displays to switch to HDMI port 1. At the same time, the TV must
also support CEC functions so that it can properly display content. When
switched "OFF" the system will turn off.
⑤
SYNC LED: The LED will illuminate when the HDMI source signal is
connected to the input port.
⑥
POWER LED: The LED will illuminate when the power is connected.
⑦
DC 5V: Plug the 5V DC power supply into the splitter and connect the
adaptor to AC wall outlet.
Note:
1. When EDID is on TV: Leave as is if the display is working properly, the
unit will detect the first HDMI output source's EDID and record into
the unit. If the first detected output source is DVI it will pass to
the next source, until the first HDMI source has been detected. The
detection priority is HDMI v1.3>HDMI v1.2 >DVI.
2. When EDID is on STD: The unit will the use its built-in EDID
3. Your EDID selection will only activated when the unit is replug and
power on.
3
Summary of Contents for CLUX-4M
