User Instructions
Cyrus integrated 6 vs2 & integrated 8 vs2
7
GB
GB
TROUBLESHOOTING GUIDE
If your
integrated 6vs2/8vs2
is not operating properly, disconnect the
power and check carefully all connections.
If you are in any doubt, consult your dealer.
No sound
Amplifier switched off or in Standby
Bring unit out of Standby
(Standby light - GREEN)
Mute is on (RED light on Vol. Ring)
Deselect Mute
Tape Monitor on (RED tape light)
De-select TAPE
Source not working
(e.g. CD not playing)
Check source
No sound from one loudspeaker
BAL control at extreme limit
Centralise Balance
Does your speaker have fuses?
Check speaker, replace fuses
Speaker cables / interconnects faulty
Check connections, cables -
replace if needed
Spurious noises from speakers
Interconnects or connections faulty
Check, replace where necessary
No response from any keys
Switch off at rear panel, wait one minute and switch on.
The problem should clear
The
integrated 6vs2/8vs2
has a unique fault indication system to help you
to diagnose problems. All fault indications appear on the Standby light on
the front panel.
Fault Indications during use
Flashing Green and Yellow
An overload condition usually
caused by excessive level or a
problem with your loudspeakers
Reduce level or Unplug speakers
amplifier should restore
Flashing Red
An internal problem with
integrated
6vs2/8vs2
or
PSX-R
Switch off and on - amplifier should
restore
Remote control not working
Remote control not operating
Check batteries
Remote control will not operate a
Cyrus
CD player or tuner
CD, TU/DAB or AV button must be
pressed before sending a command
If a fault condition still remains, return the
integrated 6vs2/8vs2
(together
with the
PSX-R
if you are using one) to your
Cyrus
appointed dealer or an
authorised Service Centre.
WARRANTY
SPECIFICATIONS
Power Supply
Voltage: .......................................................................As plate on rear of unit
Power Consumption
Standby ................................................................................................. (12W)
ON (No Load) ........................................................................................ (23W)
Maximum ......................................................... Integrated 6 vs2......... (130W)
Integrated 8 vs2......... (360W)
EMC & Safety Compliance (230V) ............................................................. CE
EMC & Safety Compliance (115V) ............................................FCC, cCSAus
Enclosure
Dimensions (WxHxD) ........................................................ 215 x 75 x 365mm
Weight.............................................................. Integrated 6 vs2 ............3.7Kg
Integrated 8 vs2............5.6Kg
Material..................................................................................Die cast chassis
Audio Performance integrated 6 vs2
Input Sensitivity (40W/8 ) .............................. Line .............................179mV
Input Impedance ............................................. Line ...............................40k
Frequency Response (-3dB) ........................... Line .................0.25Hz, 90kHz
Signal to Noise Ratio (A-WTD)........................ Line ........................... 102dBA
Power Output (both channels driven).............. 8 Ohms ...........................40W
THD+N (Pre-Amp) 1kHz.................................. Line ..........................<0.003%
THD+N (1kHz, 2/3 power) ............................... 8 Ohms ....................<0.003%
(both channels driven)
Audio Performance integrated 8 vs2
Input Sensitivity (70W/8 ) .............................. Line .............................237mV
Input Impedance ............................................. Line ...............................40k
Frequency Response (-3dB) ........................... Line ...................0.1Hz, 90kHz
Signal to Noise Ratio (A-WTD)........................ Line ........................... 102dBA
Power Output (both channels driven).............. 8 Ohms ...........................70W
THD+N (Pre-Amp) 1kHz.................................. Line ..........................<0.003%
THD+N (1kHz, 2/3 power) ............................... 8 Ohms ....................<0.003%
(both channels driven)
Cyrus reserves the right to change all specifications without notice. E &OE
The warranty card enclosed should be completed by the Dealer and the
purchaser and returned to
CYRUS
or its Distributor within 8 days of
purchase. No Dealer or Distributor may vary the terms of this warranty,
which is personal to the original Purchaser and is not transferable.
Please retain the sales receipt as proof of purchase.
Warranty claims must wherever possible be made through the Dealer
from whom the equipment was purchased.
This warranty excludes:
Damage caused through neglect, accident, misuse, wear and tear,
or through incorrect installation, adjustment or repair by
unauthorised personnel. Any unauthorised servicing will result in
loss of warranty.
Liability for damage or loss occurring in transit to or from the
purchaser.
Consequential damage, loss or injury, arising from or in conjunction
with this equipment.
Equipment for attention under warranty should be consigned return
carriage paid. If returned equipment is found to comply with the
published specification,
CYRUS
reserves the right to raise a charge.
The above conditions do not affect your statutory rights as a consumer
.