SECTION 9
TESTING COMFORT
Comfort has a Test Menu which allows the basic system operation to be
tested on a regular basis.
Press F+3
to hear the Test Menu
Press 1 for Battery Check
2 for Security Check
3 for Dial Test
4 for Siren
5 for Strobe
This allows you to test your security system.
Battery Check
Press 1 to test your standby battery. This test will turn off the mains
power to Comfort for 2 minutes . If a low battery condition is detected, a
Low Battery Alarm is generated and the Mains is turned on again.
Security Check
Press 2 for Security Check. Walk through the premises, opening
protected doors and windows and triggering detectors. All zones
activated will be announced on the Keypads. 24 hour detectors like
Smoke detectors and Panic switches can be tested without causing an
alarm or dial out. To end, press any key.
Warning:
Any 24 hour
detectors left on will cause an alarm.
Dial Test
Press 3 for Dial Test. This initiates a dial out to all the programmed
phones. On pagers, the code reported is xxxx-27-xx for Dial Test. For
Voice Phones, the Alarm Type announced is “Dial Test”. For Central
Stations, the event reported is Test. During the dial test, all tones and
sounds are audible, so you can monitor the progress of the calls.
Siren Test
Press 4 for Siren test. This produces a short burst on the siren to test
that it still working.
Strobe Test
Press 5 for Strobe Test then 1 for ON or 0 for Off. Remember to turn off
the strobe at the end of the test.
Comfort II User Manual
50