5.1
Start the Amersham ImageQuant 800
Before starting the system
Before starting the Amersham ImageQuant 800, make sure that the instrument is
connected to an external PC, see
External connections, on page 56
Start the system
Follow the steps below to start the Amersham ImageQuant 800.
Step
Action
1
Make sure that the instrument is plugged in to a mains power supply.
2
Press the power button on the right side of the instrument to activate it.
Result:
The instrument's self-diagnostic process will initialize.
Note:
The self-diagnostic process will normally take approximately 5 minutes.
Connection to a network may take longer.
3
Turn on the computer and log into Windows.
4
Tap
I Agree to agree to the End User License Agreement.
Note:
Uncheck the
Show license agreement at startup box to no longer see the
End User License Agreement at startup.
5
Enter your
Username and Password.
Note:
To disable
Turn off password protection, on page 59
.
6
Tap
Login.
5 Operation
5.1 Start the Amersham ImageQuant 800
Amersham ImageQuant 800 Operating Instructions 29372604 AC
71
Summary of Contents for AKTA go
Page 129: ...Pageintentionallyleftblank...
