No.
Part
Function
5
Slurry inlet
bottom (
SIB)
Connects to column
SIB.
6
Slurry outlet
bottom (
SOB)
Connects to column
SOB.
7
Inlet
C
Connects to slurry tank.
(The slurry tank is denoted
SLURRY on the upper
control panel.)
8
Outlet
D
Connects to waste collection tank.
(The waste collection tank is denoted
COLLECTION
on the upper control panel.)
9
Air inlet (
AIR
INLET)
Connects to pneumatic supply.
Note:
The Air inlet (
AIR INLET) has a different location on
Chromaflow Packing Station 400. For location, see
Section 4.5.2 Connect compressed air supply, on page
48
.
10
Lower control
panel
Panel for control of pump speed and position of
column nozzles.
11
START/RESET
Button to reactivate the Chromaflow Packing Station
after an emergency shutdown.
For information about emergency procedures, see
Section 2.3 Emergency procedures, on page 18
.
12
EMERGENCY
STOP
Button to stop operation immediately in an emer-
gency situation.
For information about emergency procedures, see
Section 2.3 Emergency procedures, on page 18
.
Note:
Please note that inlet
B is not shown in the schematic overview above. Inlet
B is the connection to the water/buffer tank (denoted PACKING BUFFER on
the upper control panel), and is located towards the rear of the skid, on the
same side and at the same level as the inlet
C connection.
Nozzle control
If the Chromaflow column to be primed and packed using the Chromaflow Packing
Station is equipped with automatic nozzles, the top and bottom nozzles can be
controlled from the lower operating control panel of the Chromaflow Packing Station.
For more information about Chromaflow columns and nozzle function, refer to the
column user documentation.
3 System description
3.1 Chromaflow Packing Station main components
26
Chromaflow Packing Station 50, 100, 200, and 400 Operating Instructions 29046228 AD
Summary of Contents for Chromaflow 100
Page 97: ...Pageintentionallyleftblank...
