8
Arduino standard header
9
Extra pad with standard 0.1” (2.54mm) pitch
10
PICkit header
Adapter socket (2.1mm)
DC power adaptor socket for user to plug in DC adapter. The input voltage should be ranged
from 7 to 12V.
Power LED
Power LED will light ON once the board is powered.
Run LED
Run LED will blink if CIKU in bootloader mode, and turn ON if in user mode.
Programmable LED
Programmable LED is active HIGH and it is connected to pin 13.
Mini USB B type (female)
This connector is for USB connection to upload program or power it via USB cable. A USB
Mini-B type cable is needed.
Reset button
Reset button can be used to reset/restart the CIKU program.
Bootloader button
To enter the bootloader mode, this button need to pressed (for more details, please refer to
Getting started section).
Arduino standard header
CIKU can be stacked with Arduino shield.
Extra pad with standard 0.1” (2.54mm) pitch
This extra pad allow CIKU to be stacked on donut board.
PICkit header
User can connect PICkit programmer to this header.
Created by Cytron Technologies Sdn. Bhd. – All Rights Reserved
8