Product User’s Manual – SK1632
6. HARDWARE
SK1632 comes with PICkit pin to offer simple way for downloading program via ICSP.
Downloading program into PIC is either using PICkit programmer or other compatible ICSP
does not support most of the new 16-bit and 32-bit PIC.
6.1 Loading program using PICkit Programmer
After plug in 28 pin PIC MCU (
make sure the orientation is correct
), SK1632
should be
powered either from DC adaptor, Battery or USB’s power
. To load program, one must
have the hex code. Hex code sometime called machine code. It is result after compilation.
1. Connect PICkit programmer shown as figure below. Figure below is using PICkit 3
from Microchip to load program into SK1632. Make sure the arrow at PICkit pin of
SK1632 is same side with arrow at PICkit 3 programmer.
Note:
SK1632 cannot be powered from pickit/ICSP pin as the VDD is not connected. It
must be power from either the on board USB micro B receptor or from DC jack as shown
in the picture.
Created by Cytron Technologies Sdn. Bhd. – All Rights Reserved
11
