PS-28 Cruiser
PS-28N Cruiser
CR-MM-1-0-00
CHAPTER 6 – CONTROL SYSTEM
Revision No.: -
Date of issue: 2011-03-08
6 - 18
6.3.13.2 Installation of middle two-arm lever
(a) Check condition of the control lever and lubrication of the friction surfaces. If the friction
surfaces are contaminated, then carefully remove contamination and grease them with
lubricant (see 2.6).
(b) Fit the control lever (2, Fig. 6-12) with the nylon washers (10) to the bracket (17), insert the
bolt (7) to the hole, install washer (9), screw and slightly tighten the nut (8).
(c) Secure the nut (8) with the new cotter pin (11).
NOTE:
The lever after installing must not show axial play and its travel must be
smooth without dragging.
(d) Fit the rods (13; 14) to the control lever (2), insert the bolts (4) with the first washers (6) to
the holes, install the second washers (6), screw and tighten the nuts (5).
(e) Check elevator deflections (see 6.4.3) and check plays in control (see 6.4.1).
6.3.13.3 Installation of rear two-arm lever
(a) Check condition of the control lever and lubrication of the friction surfaces. If the friction
surfaces are contaminated, then carefully remove contamination and grease them with
lubricant (see 2.6).
(b) Fit the control lever (3, Fig. 6-12) with the nylon washers (10) to the bracket (18), insert the
bolt (7) to the hole, install washer (9), screw and slightly tighten the nut (8).
(c) Secure the nut (8) with the new cotter pin (11).
NOTE:
The lever after installing must not show axial play and its travel must be
smooth without dragging.
(d) Fit the rods (14; 15) to the control lever (3), insert the bolts (4) with the first washers (6) to
the holes, install the second washers (6), screw and tighten the nuts (5).
(e) Check elevator deflections (see 6.4.3) and check plays in control (see 6.4.1).