CR-MM-1-0-00
PS-28 Cruiser
PS-28N Cruiser
CHAPTER 7 – EQUIPMENT
Date of issue: 2014-10-29
Revision No.: 11
7 - 9
WARNING:
NEVER POINT ROCKET AT ANYONE. ACCIDENTAL ACTIVATION MAY
CAUSE DEATH OR SERIOUS INJURY!
ASSEMBLY MUST BE DONE IN THIS SEQUENCE. IF DONE
INCORRECTLY, ACCIDENTAL DISCHARGE OF ROCKET MAY OCCUR
AND MAY CAUSE DEATH OR SERIOUS INJURY!
(c) Remove plastic cap (6).
CAUTION:
KEEP ALLEN WRENCH VERTICAL. BE CAREFUL NOT LO "LEVER"
WRENCH AGAINST SIDE, SO AS TO NOT ACCIDENTLY ACTIVATE
ROCKET!
(d) Remove screw (7) with 1/8 Allen wrench.
(e) Unscrew adapter (4) from rocket. Carefully remove housing (3) from rocket by turning
entire housing assembly.
(f) Loose set screws (10).
(g) Carefully remove the BRS rocket.
(h) As necessary, remove right side panel of the middle channel, unscrew the nut (14),
remove the washer (15), bolt (13) and activation housing (3).
Fig. 7-6
: BRS rocket removal / installation
1 BRS rocket
2 Rocket lanyards
3 Activation housing
4 Cone adapter
5 Steel cable
6 Plastic cap
7 Screw
8 Star washer
9 Bracket
10 Set screw
11 Rocket pedestal
12 Bracket
13 Bolt
14 Nut
15 Washer
For information:
16 Parachute