PS-28 Cruiser
PS-28N Cruiser
CR-MM-1-0-00
CHAPTER 8 – LANDING GEAR
Revision No.: -
Date of issue: 2011-03-08
8 - 16
8.3.14 Installation of brake pumps
Type of maintenance: line
Authorization to perform:
-
Sport pilot or higher
Tools needed:
-
wrench size 1/2 in, 3/8 in
(a) Insert the brake pump (1; 2, Fig. 8-12) according to the figure to the floor bracket (14) and
install the bolt (4) with the nut (5) and washer (6); secure the nut by the new cotter pin (7).
(b) Connect brake pump rod end eye with pedal (14) by means of the bolt (8) with the nut (11),
spacers (9; 10) and washer (12); secure the nut by the new cotter pin (7).
(c) Reinstall the brake system hose (3) on the brake pump (1; 2) and on the brake cylinder on
main landing gear.
(d) Fill the brake system with brake fluid and air-bleed it (see 8.5.4.).
1 Pilot brake pump
9
Spacer
2 Copilot brake pump
10 Spacer
3 Brake hose
11 Nut
4 Bolt
12 Washer
5 Nut
For information:
6 Washer
13 Bracket
7 Cotter pin
14 Rudder pedal
8 Bolt
Fig. 8-12
: Brake pumps removal / installation