PS-28 Cruiser
PS-28N Cruiser
CR-MM-1-0-00
CHAPTER 9 – FUEL SYSTEM
Revision No.: 1
Date of issue: 2011-07-08
9 - 16
Cleaning procedure
(a) Move the fuel selector valve to the
OFF
position.
(b) Use the drain valve to drain the existing fuel from the gascolator bowl.
(c) Remove the lockwire from nut (3. Fig. 9-8).
(d) Loose the nut (3) and remove the gascolator bowl (4) and the gasket (5).
(e) Use a small pointed tool to lift the edge of the filter screen (6) and carefully remove it for
cleaning.
(f) Clean the filter screen (6) by washing in fuel, or it can be blown off using an air line; inspect
bowl (4) and clean if required.
(g) Carefully install the filter screen (6) to the gascolator body, insert the gasket (5) and the
gascolator bowl (4); make sure to correct installation.
(h) Tighten the nut (3) and secure it by lockwire.
(i) Move the fuel selector valve to
LEFT
/
RIGHT
position; check the gascolator for fuel leak.
Fig. 9-8
: Fuel filter cleaning
1 Gascolator body
2 Stirrup
3 Nut
4 Gascolator bowl
5 Gasket
6 Filter screen