CR-MM-1-0-00
PS-28 Cruiser
PS-28N Cruiser
CHAPTER 10 – POWERPLANT
Date of issue: 2011-03-08
Revision No.: -
10 - 31
WARNING:
ENGINE IGNITION MUST BE SWITCHED OFF!
(a) As necessary, screw the silentblocks (4, Fig. 10-18) to the cooler.
(b) Put the cooler on the lower (2) and the upper brackets (3).
(c) Install the washers (6), screw and tighten the nuts (5); tighten the bolts (7).
(d) Install hoses (10) on the cooler outlets and secure them with hose clamps (9).
(e) Fill the cooling system with cooling liquid (see 10.5.2) and check system tightness.
(f) Install the lower and upper engine cowling.
10.3.19
Throttle and choke control levers removal
Type of maintenance: line
Authorization to perform:
See point 2.5.3.
Tools needed:
-
wrench size No.14
-
Allen wrench size No. 2
-
screwdriver
-
cutting pliers
WARNING:
ENGINE IGNITION MUST BE SWITCHED OFF!
(a) Remove the cover (11, Fig. 10-19) from the middle channel.
(b) Remove the upper engine cowling.
(c) Disconnect the throttle (7) and choke (9) cables from carburetor levers (12; 3) and from the
throttle and choke control levers (1).
(d) Unscrew the nuts (5), remove washers (6), bolts (2), bushings (3; 4) and the throttle control
lever witch choke (1) from the middle channel.
