PS-28 Cruiser
PS-28N Cruiser
CR-MM-1-0-00
CHAPTER 12 – INSTRUMENTS AND AVIONICS
Revision No.: 23
Date of issue: 2020-01-15
12 - 74
2. Solder a sufficient length of AWG20 wire on the diode assembly, see Figure 12-50.
Figure 12-51.
Diode assembly adjusted for installation on PS-28 Cruiser
Diode assembly installation
(refer to Figure 12-52)
:
1. Remove connector (female Faston) from the positive terminal on the starter relay and cut the
connector away from the wiring. Remove fixing stripes of the wiring as needed and add the
soldered AWG20 wiring of the diode assembly and complete new connector. Use fixing stripes
as needed to tie the wiring.
2. Install the connector back in the positive terminal of the starter relay.
3. Remove one mounting bolt and hardware from the starter relay mounting base.
4. Place the ground connection ring terminal of the diode assembly on the mounting bolt and
reinstall the bolt through the starter relay base. The bolt is now the “ground” connection for the
diode assembly, see Figure 12-52.
Functional check:
5. Reconnect the battery.
6. Perform a functional check of the switch by starting the engine and checking the magnetos for
normal engine drop. Reduce engine RPM to idle and turn the switch off momentarily to verify
that the „Off“ position stops the engine.
7.
Restore aircraft to original operating configuration.