PS-28 Cruiser
PS-28N Cruiser
CR-MM-1-0-00
CHAPTER 13 – VENTING / HEATING
Revision No.: 6
Date of issue: 2013-01-11
13 - 6
13.3.3
Air vents removal
(a) Unscrew the vent (1, Fig. 13-5) and remove it.
(b) Push back the tube (2), remove the cable tie (4) and pull the hose (3) out from the tube
(2).
Fig. 13-5
: Air vents removal / installation
13.3.4
Air vents installation
(a) Put the hose (3, Fig. 13-5) to the tube (2) and secure with the cable tie (4).
(b) Insert the tube (2) to the hole in the instrument panel (5), screw and tighten the vent (1).
(c) Check the vent (1) movement.
13.3.5
Heat exchanger removal
NOTE:
Removal of the standard heat exchanger is shown in Section 10.3.13.
Type of maintenance: line
Authorization to perform:
-
Sports pilot or higher
Tools needed:
-
Screwdriver, pliers, cutting pliers
1 Vent
2 Tube
3 Hose
4 Cable tie
For information:
5 Instrument