CR-MM-1-0-00
PS-28 Cruiser
PS-28N Cruiser
CHAPTER 6 – CONTROL SYSTEM
Date of issue: 2018-09-27
Revision No.: 22
6 - 13
6.3.9 Installation of aileron control lever behind the seats
Type of maintenance: heavy
Authorization to perform:
See point 2.5.3.
Tools needed:
-
wrench size 7/16 in
(a) Check condition of the control lever and lubrication of the friction surfaces. If the friction
surfaces are contaminated, then carefully remove contamination and grease them with
lubricant (see 2.6).
(b) Fit the control lever (1, Fig. 6-10) with the nylon washers (11) to the bracket (15), insert the
bolt (8) to the hole, install washer (10), screw and slightly tighten the nut (9).
(c) Secure the nut (9) with the new cotter pin (12).
NOTE:
The control lever must not show axial play after installing and its travel must
be continuous without dragging.
(d) Fit the rods (13; 14) to the control lever (1), insert the bolts (2; 5) with the first washers (4;
7) to the holes, install the second washers (4; 7), screw and tighten the nuts (3; 6).
(e) Tilt the seat backs to backwards.
(f) Check aileron deflections (see 6.4.3) and check plays in control (see 6.4.1).
