CR-MM-1-0-00
PS-28 Cruiser
PS-28N Cruiser
CHAPTER 6 – CONTROL SYSTEM
Date of issue: 2011-03-08
Revision No.: -
6 - 15
NOTE:
The bell cranks located on the bracket in the position of the rear rib No. 7
between the spars. Removal is identical for the left and the right aileron bell
crank.
a) Unscrew the screws (13, Fig. 6-11) and remove the cover (12).
b) Unscrew the nuts (8), remove the washers (4), bolts (7), and disconnect the rods (9; 10)
from the bell crank (1).
c) Remove the cotter pin (6), unscrew the nut (3), remove the washers (4; 5), bolt (2), and the
bell crank (1).
1 Aileron bell crank
8
Nut
2 Bolt
9
Control rod I
3 Nut
10 Control rod II
4 Washer
11 Bracket
5 Nylon washer
12 Cover
6 Cotter pin
13 Screw
7 Bolt
Fig. 6-11
: Aileron bell crank removal / installation
NOTE
Figure shows the left aileron
bell crank.