PS-28 Cruiser
PS-28N Cruiser
CR-MM-1-0-00
CHAPTER 9 – FUEL SYSTEM
Revision No.: 22
Date of issue: 2018-09-27
9 - 10
9.3.2 Fuel tank installation
Type of maintenance: heavy
Authorization to perform:
See point 2.5.3.
Tools needed:
-
wrench size No. 8, 1/2 in,
-
screwdriver
-
riveting pliers
-
cutting pliers, pliers
(a) Remove any hole seals from the tank.
(b) Set the tank to the position between the ribs No.4 and 6a. Before installing the tank, check
the cork bands for completeness and damage. Change them, if needed.
(c) Connect fuel quantity sensor wire, insert the finger screen – use LOCTITE 565 or equivalent
sealant.
(d) Close the leading edge skin on the wing and fit it to the spars and ribs per clecos each
second hole through of securing harnesses.
(e) Rivet the skin on the ribs and spar.
(f) Screw back filler cap - use silicon to make connection of filler cap flange and wing skin
watertight.
(g) Install the wing (see 4.3.2).
(h) Check the fuel system (see 9.4.1).
(i) Connect the battery ground.
9.3.3 Removal of the finger screen
Type of maintenance: line
Authorization to perform:
See point 2.5.3.
Tools needed:
-
screwdriver
-
socket wrench 11/16 inch
NOTE:
The finger screen is located in the root tank rib.
(a) Drain fuel from the fuel system.
(b) Remove the wing (see 4.3.1).
(c) Remove the hose clamp (3, Fig. 9-5) and disconnect the fuel hose (4).
(d) Remove the finger screen (2).
