CR-MM-1-0-00
PS-28 Cruiser
PS-28N Cruiser
CHAPTER 9 – FUEL SYSTEM
Date of issue: 2011-03-08
Revision No.: -
9 - 13
(a) Set the gasket (2, Fig. 9-6) on the fuel tank flange.
(b) Set position and length of the fuel quantity sensor lever according to the Fig. 9-4.
(c) Carefully put the fuel quantity sensor (1) into the tank and attach it using bolts (3) with
washers (4) – use LOCTITE 565 or equivalent sealant on bolts thread.
(d) Connect electrical wires (5) to the fuel quantity sensor (see Wiring Manual).
(e) Check fuel system tightness (see 9.4.1).
(f) Connect the battery and check fuel gauge function.
(g) Install (rivet) the cover plate (6).
9.3.7 Fuel drain valve removal
Type of maintenance: line
Authorization to perform:
-
Sport pilot or higher
Tools needed:
-
wrench size 1/2 in
NOTE:
The fuel drain valves are located on bottom side of the wings and on the
gascolator.
(a) Drain the fuel from the tank or gascolator.
(b) Unscrew drain valve (1, Fig. 9-7) from the tank (2) or gascolator.
(c) Check “O” ring and the valve spring.
1 Fuel drain valve
2 Fuel tank flange
Fig. 9-7
: Fuel drain valve removal / installation
NOTE
Figure shows the fuel
drain valve on the left
wing.
