PS-28 Cruiser
PS-28N Cruiser
CR-MM-1-0-00
CHAPTER 10 – POWERPLANT
Revision No.: 24
Date of issue: 2020-11-19
10 - 16
10.3.3 Klassic 170/3/R propeller removal
Type of maintenance: line
Authorization to perform:
See point 2.5.3.
Tools needed:
-
wrench size No.13, No. 16 (5/8”)
-
Allen wrench size No. 6
-
screwdriver
-
cutting pliers, pliers
WARNING:
ENGINE IGNITION MUST BE SWITCHED OFF!
(a) Disconnect the battery and remove upper line of spark plugs from the engine.
(b) Unscrew the screws (11, Fig. 10-10) with the washers (12) and remove the propeller spinner
(2).
(c) Cut of the lockwire securing the bolt heads (7).
(d) Unscrew and remove the bolts (7) with the washers (10) and take out the propeller along
with spinner flange (9) from the spacer (3).
(e) Put the protective covers on the propeller blades and store the propeller on a safe place so
that no damage can occur.
Fig. 10-10
: Klassic 170/3/R propeller removal / installation
10.3.4 Klassic 170/3/R propeller installation
Type of maintenance: line
Authorization to perform:
See point 2.5.3.
1 Propeller
2 Propeller spinner
3 Spacer
4 Drive bushing (6 pcs.)
5 Bolt (6 pcs.)
6 Propeller flange
7 Bolt (6 pcs.)
8 Nut (6 pcs.)
9 Spinner flange
10 Washer (12 pcs)
11 Screw (6 pcs.)
12 Washer (6 pcs.)