1
6
LCD SCREEN
The LCD is an easy to use screen that gives the owner / installer information regarding programming and
motor status. Whenever the motor is programmed or a fault occurs, refer to the screen for diagnostic assis
tance. In certain cases the screen will give a message that reads “Call Technician’ this means that the motor
needs to be checked by an installer. The messages on the screen are generally self explanatory. However
the following table gives a description of the messages and their meaning.
MESSAGE
MEANING / ACTION
LOW BATTERY
THIS MESSAGE WILL SHOW AFTER INITIAL START UP, IF
THE LOW BATTERY MESSAGE REMAINS AFTER THE
MOTOR IS TRIGGERED :
CHECK BATTERY VOLTAGE / CHECK CHARGER VOLTAGE
MAINS FAIL
CHECK THE MAINS POWER / CHECK TRANSFORMER /
CHECK CHARGER.
GATE CLOSED
THE GATE IS IN THE CLOSED POSITION.
GATE OPEN
THE GATE IS IN THE OPEN POSITION.
OBSTRUCTION
THE GATE HAS SENSED AN OBSTRUCTION. CHECK THE
WHEELS / ROLLERS/ RACK/ BRACKETS/ FUSES/ FORCE
SETTING POTS.
AUTOCLOSE ACTIVE
THE GATE IS SET TO AUTO CLOSE.
PARTY MODE
THE GATE IS IN AUTOCLOSE OVERRIDE .
PROGRAM MODE
THE GATE IS IN PROGRAM MODE.
PROGRAMMING CLOSE POSTION
THE GATE IS CLOSING WHILE PROGRAMMING.
MARKER OK
THIS MESSAGE WILL SHOW WHEN THE MAGNET PASSES
THE MARKER. THIS INDICATES THAT THE MARKER IS IN
WORKING ORDER.
PROGRAMMING OPEN POSITION
THE GATE IS OPENING WHILE PROGRAMMING.
PROGRAM COMPLETED
REMOVE LINK
THE PROGRAM IS COMPLETE. REMOVE THE PROGRAM
LINK.
SERVICE DUE
THE MOTOR REQUIRES A SERVICE.
NO REV PULSES
FAULTY REV COUNTER, PC BOARD MOUNTING MAY BE
LOOSE, MAGNET HOLDER BROKEN.
BEAMS BLOCKED
THE INFRARED SAFETY BEAMS ARE BLOCKED / FAULTY/
THE BEAMS LINK HAS BEEN REMOVED.
LCD SCREEN
Some of the messages below have been shortened to
show the main message. Certain messages will also
show the action needed.
