Description:
VANTEC-18A
1)
INPUT connectors
:
1/4” Jack+XLR c
ombined socket-type input signal connectors. This is a balanced connector just like the LOOP THRU
connector with the following pin assignments
:
1 or S =GND (ground).
2 or T =(+) Non inverted input.
3 or R =(-) Inverted input.
2)
SATELLITE
OUTPUT
A and B, XLR-type output signal connectors for connecting several units together and sending them all the same input signal
or filtered signal (by using THRU/HPF).
3) LIMIT:
Red LED indicates amplifier saturation. Amplifier limiter indicator lights.
4) SIGNAL:
Green LED indicates signal presence.
5) ON:
Green LED indicates that the unit is ON.
6) SUB LEVEL:
Potentiometer for adjusting the unit level.
7) AC INPUT
:
Standard PowerCon NAC3FCA mains connector
(inserted, rotated and locked for ON). Only use this equipment
with an appropriate mains cord.
8)
THRU/HPF
:
‘SATELLITE OUTPUT’ selector to switch between full
range signal or pass filter with cut-off frequency of 100 Hz.
9)
LOW-PASS CROSSOVER
:
Button for adjusting the upper cut-off frequency for the
subwoofer unit. We recommend a cut-off frequency of 100 Hz
for vantec series use.
10)
PHASE
:
Switch for inverting the phase of the unit.
11)
PRESET DEEP/LOUD
Button for switching between two types of frequency
response, DEEP or LOUD.
12)
AC OUTPUT:
PowerCon NAC3FCB connector for AC loop thru allows up
to 8 units when using a 230V version (see unit’s label)). Only
use this equipment with an appropriate mains cord.
23
OUTPUT A
OUTPUT B
HPF/THRU
SATELLITE X-OVER
LIMIT
SIGNAL
ON
-
+
POLARITY
CAUTION
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE
RISK OF ELECTRIC SHOCK
DO NOT OPEN
LEVEL
+6
-oo
0
LOW-PASS
125Hz
80Hz
100Hz
DAS Audio Group, S.L. (Valencia)
MADE IN SPAIN
INPUT A
INPUT B
115/230 V~ 50/60Hz 500W
AC INPUT
MAX. 6@230V / 2@115V
UNITS VANTEC-18A
AC OUTPUT
DEEP/LOUD
PRESET
www.dasaudio.com
OFF/ON
LED
VANTEC
series
Model: VANTEC-18A
1
2
3
4
9
5
11
12
8
6
10
7
Manual del Usuario
/ vantec series /
User’s Manual
