3
CUTTING AND C
Installation of the Cutter(1)
Install the wheel assembly to the cutter
base with provided nuts as shown.
Warning:
Do not put your fingers
against the sharp edge of the blade at
any time.
Straight Cut
Insert the floor plank between the
cutting blade and the base, flush with
the guide bar on the working table and
hold the plank then pull handle down
to complete a cut.
Warning:
Maintain control of the
handle. Do not allow handle to slam
back after making a cut.
Installation of the Cutter (2)
Install the handle assembly to the cutter
base with provided screws as shown.
Warning:
Do not put your fingers
against the sharp edge of the blade at
any time.
