3
SET UP
CUTTING AND C
Installation of the Cutter (2)
Pull up the lock pin on the
aluminum handle as shown and
insert the handle into the
handle base as shown.
Warning:
Do not put your
fingers against the sharp edge
of the blade at any time.
Installation of the Cutter (1)
Install the table to the cutter
base with the provided screws
and bolts as shown.
Warning:
Do not put your
fingers against the sharp edge
of the blade at any time.
Cutting Preparation
Adjust the angle attachment to
desired angle as needed.
The
angle attachment can be used
on left side of the table as shown.
Warning:
Do not put your fingers
against the sharp edge of the
blade at any time.
