Attachment
Use the attachment shown
in Fig.10 as a limitation
stopper when repeatedly
cutting same size of the tile.
Warning:
Remove this attachment
from the table when not
needed.
Fig.10
0-90 Degree Attachment
Unlock the screw o
attachment shown in Fig.11
and set it to the proper
angle between 0-90
degrees, then lock the
degree setting screw.
Warning:
Remove this attachment
from the table when not
needed.
n the
Fig.11
45 Degree Attachment (2)
Set this attachment in right
position where 45 Degree is
assured, then lock the
attachment to the table
back shown in Fig.12.
Warning:
Remove this attachment
from the table when not
needed.
Fig.12
8
