KA 34: 300** N, 11,8 mm/s =
“-HS” KA 34 12,2 mm/s =
(with tensile force (1/2 nominal load) 16,1 mm/s)
KA 54: 500** N, 11,8 mm/s =
“-HS” KA 54 13,3 mm/s =
(with tensile force (1/2 nominal load) 17,2 mm/s)
main
closing
edge
beside closing edge
beside
closing edge
Clamping protection
In "CLOSE" direction the drive has an active
clamping protection for the main closing edge. With
an overload in the closing range 3 and 2 the drive
runs "OPEN" for 10 seconds, then drive "CLOSE"
again. If after three attempts a closing is not possible,
the drive remains in this position.
In addition, the drive has a passive clamping
protection. The closing speed in closure Range 2
and 1 is reduced to 5 mm/s.
Higher forces can occur on besides
closing edges. Danger of violent
pressure in handaccessible area.
Technical data
Type
KA 34
KA 54
Power supply
24 V DC / ±15% / 1,0 A
24 V DC / ±15% / 1,4 A
Nominal force
300 N
500 N
Nominal locking force
1000 N
Lifetime
>10 000 double strokes
Duty cycle
30 % (with cycle time 10 minutes)
Housing
anodized aluminium
Ingress protection
IP 32
Temperature range
-5 ... +75°C
Fire stability
30 min / 300°C
Nominal stroke length * ** see type plate
Additional functions **
clamping protection activated (3 stroke repeatings), locking relief activated
* adjustable with PLP 1
** programmable with PLP 1 and PDA Servicetool
(with covering stoppers delivered with bracket sets)
/
Running speed and forces
** + 20 % switch-off reserve
(temporary)
77mm
KA
34:
300**
N,
11,8
mm/s
KA
54:
500**
N,
11,8
mm/s
5 mm/s
150
N
23mm
I
II
III
5mm/s
150
...
250
N
Closure
Ranges
99.823.88 2.0/11/09
6/12
English
Normal operation =
SHEV- fast running =
KA 34 / KA 54
