17
- GB
GB -
18
ENGLISH
ENGLISH
TREATMENT PROCEDURE
1. Clean the area to be treated that you have previously shaved;
2. Cover any moles with a white make-up pencil or a specific product such
as D Light Patch Pro
3. Turn on the device and select the desired treatment using the FUNCTION
button:
HR
for epilation or
SR
for photorejuvenation
4. Select the desired operating mode using the MODE button:
EXP
for
single shot or
OPT
for slide mode.
5. Select the desired power level from 1 to 3 using the ENERGY button
referring to the phototype table included in this pack and at the end of the
manual.
6. Wear protective goggles.
7. Place the head emitter in touch with the skin and unlock the flash delivery
by quickly pressing the firing button on the handpiece twice.
HR mode (Epilation)
(EXP mode)
: when the firing button is pressed, 2 consecutive flashes are
released which are used to treat the same area: the first weaker pre-heats
the skin to prepare it for the second (more intense) which deactivates the
hair bulb. Once the 2 flashes have finished, go to the next area and press
the shot button again to treat it as done previously.
(OPT mode)
: hold down the firing button and slide the head over the area
to be treated while the device delivers flashes continuously. Avoid stacking
more than 2 flashes on the same area.
SR mode (Skin Rejuvenation)
(EXP mode):
when the fire button is pressed, a flash is emitted which is
used to treat the area, once the flash is over, move to the next area and
press the fire button again to treat it. Avoid overlapping more than one
flash on each area to be treated.
(OPT mode)
: hold down the firing button and slide the head over the area
to be treated while the device delivers flashes continuously, avoid
overlapping more than 2 flashes on the same area to be treated.
8. Clean the treated area after the operation;
9. Apply D Light Post treatment cream included in the package and massage
until completely absorbed.
RECOMMENDATIONS
Do not use the pulsed light on moles, tattoos, birthmarks and wherever
the skin has pathologies or lesions of any kind.
When solar radiation is intense, for 7 days following treatment, it is
recommended to apply a sunscreen with almost SPF 50 filter on the
treated areas that are exposed to the sun and avoid tanning or sun
lamps.
SIGNS OF TREATMENT EFFECTIVENESS
If after the hair removal treatment the skin is reddened and there is a
sensation of heat, it is a sign that the treatment has been effective.
Normally, these sensations disappear within a couple of hours.
FEELING OF DISCOMFORT
There may be a slight discomfort during the treatment which people
compare to the snap of an elastic on the skin, this is absolutely normal, if
instead of feeling pain, stop the treatment and lower the potency.
