16
Ad-Hoc Channel:
All devices in the Ad-Hoc net-
work must be set to the same
channel.
Click Apply if you have made any changes.
Data Packet Parameter:
Set the Fragmentation Threshold and the RTS Threshold. Please see below.
Profile IP Settings:
You can Enable or Disable the IP Settings portion of your profile here. If you select
Disable you will need to configure the IP address information each time you connect to
a network. If you select Enable you will maintain the same IP address information each
time you connect to a network.
Select Enable or Disable.
Launch Utility on Startup:
Power Mode:
Disable -This default setting consumes the most power.
Enable - This setting consumes the least power.
Fragmentation Threshold:
This value should remain at its default setting of 2432. If you experience a high packet
error rate, you may slightly increase your Fragmentation Threshold within the value
range of 256 to 2432. Setting the Fragmentation Threshold too low may result in poor
performance.
This value should remain at its default setting of 2432. If inconsistent data flow is a
problem, only a minor modification should be made.
RTS Threshold:
Using the Configuration Utility (continued)
Advanced
Starting Ad-Hoc Network:
This setting is always 2.4GHz.
Super G:
Enable or Disable the Super G
function (108Mbps). In order to
communicate, all devices must
share the same setting for this
feature.
Frequency:
Select 802.11b/g - 2.4GHz or
802.11b.
