19
Frequency:
Select the network fre-
quency from these op-
tions:
Auto
;
b 2.4GHz
;
b/g
2.4GHz
;
or
a 5GHz
.
Profile IP Settings:
You can
Enable
or
Disable
the
IP Settings
portion of your profile here. If you
select
Disable
you will need to configure the IP address information each
time you connect to a network. If you select
Enable
you will maintain the
same IP address information each time you connect to a network.
Starting Ad-Hoc Network:
If you are configuring an
Ad-Hoc network, select
2.4GHz
or
5GHz
.
Select
Auto
or
1-11
.
Ad-Hoc Channel:
Using the Configuration Utility
(continued)
Data Packet Parameter:
Set the
Fragmentation Threshold
and the
RTS Threshold
. Please see below.
Fragmentation Threshold:
This value should remain at its default setting of 2346. If you experience a high
packet error rate, you may slightly increase your fragmentation threshold within
the value range of 256 to 2346. Setting the fragmentation threshold too low may
result in poor performance.
This value should remain at its default setting of 2346. If inconsistent data flow
is a problem, only a minor modification should be made.
RTS Threshold:
Advanced
Power Mode:
Disable
- Saves no power.
Fast Save
- Moderate power-saving.
Max Save
- Saves the most power.
Select
Enable
or
Disable
.
Launch Utility on Startup:
Enable
or
Disable
.
XR Mode:
Enable
or
Disable
.
Super A/G:
