D-Link DWL-7700AP User Manual
34
Section 3 - Configuration
Choose full, half (-3dB), quarter (-6dB), eighth (-9dB), minimum power.
*Maximum wireless signal rate derived from IEEE Standard 802.11a and 802.11g specifications. Actual data throughput will vary. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network overhead lower actual data throughput rate.
Radio:
Select
ON
or
OFF
.
(Wi-Fi Multimedia) Improves the user experience for audio, video, and voice applications over a Wi-Fi network.
This feature is enabled by default, uncheck to disable.
WMM:
Internet Group Management Protocol (IGMP) snooping allows the AP to recognize IGMP queries and reports sent
between routers and an IGMP host (wireless STA). When enabled IGMP snooping, the AP will forward multicast
packets to IGMP host based on IGMP messages passing through the AP.
IGMP Snooping:
Specify the data rates at which the DWL-7700AP should transmit signals. For 802.11a, choose from 9Mbps,
18Mbps, 36Mbps, 48mbps, and 54Bbps. For 802.11b, choose from 5.5Mbps, 11Mbps. For 802.11g, choose from
9Mbps, 18Mbps, 36Mbps, 48Mbps, and 54Mbps. For 802.11b/g, choose from 6Mbps, 9Mbps, 12Mbps, 18Mbps,
24Mbps, 36Mbps, 48Mbps, and 54Mbps.
Advance Data
Rate Settings:
RTS Length:
Transmit Power:
This value should remain at its default setting of 2346. If you encounter inconsistent data flow, only minor
modifications to the value range between 256 and 2346 are recommended
