D-Link DWL-7700AP User Manual
37
Section 3 - Configuration
VLAN ID:
If you are enabling Guest access and configure Internal and Guest networks on the VLAN, this field will also
be enabled.
Provide a number between 1 and 4094 for the Internal VLAN.
This will cause the access point to send DHCP requests with the VLAN tag. The switch and the DHCP server
must support VLAN IEEE802.1Q frames. The access point must be able to reach the DHCP server.
Check with the Administrator in regards to VLAN and DHCP configurations.
You can enable this function to untag the packets from wireless to Ethernet if VLAN is enabled.
Specify the 0-7 priority queue when priority is enabled
Select Enable or Disable .
Select Hex or ASCII.
Select from 64-Bits, 128-Bits, and 152-Bits.
Select from the 1st to 4th key to be set as the active key
Key Type:
Key Size:
Key:
WMM:
Ethernet Without
Tag:
Priority:
Security:
VLAN Tag Mode:
The Multi-SSIDs security can be WPA/WPA2-Enterprise or WPA-Auto-Enterprise only when the Primary SSID’s
security is at the same security level. Also. They must also connect to the same RADIUS server.
Select Manual or Dynamic. You can input the VID manually, or configure as dynamic, station can get specific
VLAN Tag from RADIUS server to work with VLAN supported switches or other devices when the Primary SSID’s
security is set to WPA-Enterprise, WPA2-Enterprise, WPA-Auto-Enterprise.