Troubleshooting
(continued)
uninstall the drivers, restart the system, and repeat the driver
installation procedure.
4. The computer with the wireless adapter installed is unable to
connect to the wireless network.
•
In
Infrastructure
mode, make sure the same
Service Set Identifier
(SSID)
is specified on the settings for the wireless clients and access
points. The
SSID
factory default setting for the D-Link
AirPro
products is
Default.
(Please refer to
Checking the Wireless
Configuration
in the
Networking Basics
section of this manual for
more information.)
•
In
Ad-Hoc
mode, both wireless clients will need to have the same
SSID
. Please note that it might be necessary to set up one client to
establish a
BSS (Basic Service Set)
and wait briefly before setting
up other clients. This prevents several clients from trying to establish
a
BSS
at the same time, which can result in multiple singular
BSSs
being established, rather than a single
BSS
with multiple clients
associated to it. (Please see the
Status Tab
in
Linkmon
in the
Configuration Utilities
section or see
Checking the Wireless
Configuration
in the
Networking Basics
section of this manual to
learn more about
BSS-Basic Service Set.
)
•
Check that the
Network Connection
for the wireless client is
configured properly. Select
AP (Infrastructure)
when connecting to
an access point and select
Ad-Hoc mode
when connecting without
an access point.
Double-click
on the
network connection
icon
in
the taskbar > click on
Properties
> click on
Configure
> select the
Settings
Tab > click on
Modify
to change the settings for the
wireless adapter. (Please refer to
Checking the Wireless
Configuration
in the
Networking Basics
section of this manual for
more information.)
•
Verify that the
Turbo Mode
setting is exactly the same for wireless
clients and the access point. Please note that the wireless
connection will not be established in
Infrastructure
or
Ad-Hoc
mode
if
Turbo Mode
is enabled on one end of the wireless connection and
not the other. (Please refer to
Checking the Wireless
Configuration
in the
Networking Basics
section of this manual for
more information.)
•
If
Enable Security
is selected, make sure that the correct encryption
keys are entered on both the wireless clients and the access points.
