48
D-Link COVR-2202 User Manual
Section 3 - Configuration
DHCP Server
Status:
Enable or disable the DHCP server.
DHCP IP Address
Range:
Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
Note:
If you have reserved static IP addresses to client devices, make
sure the IP addresses are outside of this range or you might have an IP
conflict. Refer to
Connected Clients
section page
for how reserve
IP addresses for clients.
DHCP Lease Time:
Enter the length of time for the IP address lease (in minutes).
Always Broadcast:
Enable this feature to broadcast your network's DHCP server to LAN/
WLAN clients.
Advanced Settings
WAN Port Speed:
You may set the port speed of the Internet port to
10 Mbps
,
100
Mbps
,
1000 Mbps
, or
Auto
(recommended).
UPnP:
Enable or disable Universal Plug and Play (UPnP). UPnP provides
compatibility with networking equipment, software, and peripherals.
IPv4 Multicast
Streams:
Enable to allow IPv4 multicast traffic to pass through Covr Point A
from the Internet.
IPv6 Multicast
Streams:
Enable to allow IPv6 multicast traffic to pass through Covr Point A
from the Internet.
Click
Save
when you are done.
Network (Continued)
