DGS-3048 Gigabit Ethernet Switch Manual
Parameter Description
From
and
To
Enter the port or ports to be set.
PortControl
This allows you to control the port authorization state.
Select
forceAuthorized
to disable 802.1x and cause the port to transition to the
authorized state without any authentication exchange required. This means the port
transmits and receives normal traffic without 802.1x-based authentication of the
client.
If
forceUnauthorized
is selected, the port will remain in the unauthorized state,
ignoring all attempts by the client to authenticate. The Switch cannot provide
authentication services to the client through the interface.
If
auto
is selected, it will enable 802.1x and cause the port to begin in the
unauthorized state, allowing only EAPOL frames to be sent and received through
the port. The authentication process begins when the link state of the port
transitions from down to up, or when an EAPOL-start frame is received. The Switch
then requests the identity of the client and begins relaying authentication messages
between the client and the authentication server.
The default setting is
auto
.
TxPeriod
This sets the TxPeriod of time for the authenticator PAE state machine. This value
determines the period of an EAP Request/Identity packet transmitted to the client.
The default setting is
30
seconds.
QuietPeriod
This allows you to set the number of seconds that the Switch remains in the quiet
state following a failed authentication exchange with the client. The default setting is
60
seconds.
SuppTimeout
This value determines timeout conditions in the exchanges between the
Authenticator and the client. The default setting is
30
seconds.
ServerTimeout
This value determines timeout conditions in the exchanges between the
83
Summary of Contents for D DGS-3048 DGS-3048
