DAP-1150
Wireless Access Point Supporting Router Mode
User Manual
Configuring Device (Router Mode)
Creating PPTP + Dynamic IP or L2TP + Dynamic IP WAN Connection
To create a connection of the PPTP + Dynamic IP or L2TP + Dynamic IP type, click the
Add
button
on the
Net / WAN
page. On the opened page, select the relevant value from the
Connection
Type
drop-down list and specify the needed values.
Figure 106. The page for creating a new connection. The
General settings
and
Ethernet
sections.
Parameter
Description
General settings
Port
A physical interface to which the new connection will be assigned.
Name
A name for connection for easier identification.
Enable
Select the checkbox to enable the connection.
Direction
The direction of this connection.
Ethernet
MTU
The maximum size of units transmitted by the interface.
MAC
A MAC address assigned to the interface. This parameter is
mandatory if your ISP uses MAC address binding. In the field, enter
the MAC address registered by your ISP upon concluding the
agreement.
You can click the
Clone MAC
button to set the MAC address of
the network interface card (of the computer that is being used to
configure the access point at the moment) as the MAC address of
the WAN interface.
Also you can set the address of a device connected to the access
point's LAN at the moment. To do this, select the relevant value
from the drop-down list located to the right of the field (the field
will be filled in automatically).
Page
118
of 175
