D-Link Nuclias Cloud-Managed Wireless VPN Gateway
3
E
NG
L
IS
H
Connecting Power and Turn the Device
On/Off
Installing and Connecting the
Device
This chapter describes how to connect cables and
power to the device.
Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures and injuries:
- Before installation, always check that the power
supply is disconnected
- Ensure that the room in which you operate the
device has adequate air circulation and that
the room temperature does Not exceed 40˚C
(104˚F)
- Allow 1 meter (3 feet) of clear space to the front
and back of the device.
- Do not place the device in an equipment rack
frame that blocks the air vents on the sides of
the chassis. Ensure that enclosed racks have
fans and louvered sides.
- Correct these hazardous conditions before
any installation: moist or wet floors, leaks,
ungrounded or frayed power cables, or missing
safety grounds.
The AC/DC Power Adapter shipped with the
device connects the device to earth ground when
plugged an AC grounding-type power outlet. The
device must be connected to earth ground during
normal operation.
To connect power to the device, plug the AC/DC
power adapter into the DC power phone jet on the
DBG-X1000 Default Interface Settings
Ethernet
Interface
Interface
Type
IP Address
Web-Based
Management
DHCP
Client
LAN(1-4) /
WLAN
Static IP
192.168.10.1
Enabled
Enabled
WAN
DHCP
Client
0.0.0.0
Disabled
Disabled
Table 3: Default Interface Settings
Note:
DBG-X1000 allows Web GUI access
from LAN and Wireless interfaces by default for
security reason.
back panel of the device.
Note: We recommend using a surge protector for
the power connection.
To power on the DBG-X1000 device, press the
DC power switch on the rear panel to the on
position. To power off the device, press the power
switch to the off position.
Connecting the Device to a Network
This section provides basic information about
physically connecting the DBG-X1000 to a
network. To connect the necessary cables as
shown in Figure 3.
1. Connect an RJ-45 cable from the port labeled
WAN to the external router. The port WAN is
pre-allocated to the WAN network segment.
2. Connect an RJ-45 cable from the port labeled
LAN (1-8) to a switch in the LAN network
segment.
3. Connect an RJ45-to-DB9 cable from the
console port for CLI (Command Line Interface)
management access.
Figure 3. Basic Cabling Example
WAN
LAN
Console
Internet
Switch
User
