30
D-Link DCS-1100/1130 User Manual
Section 4 - Configuration
Recording Options
Resolution
: This will let you set which video profile you wish to use to
record video. Please note that if the bitrate (bps) of the video profile is
higher than your Samba network drive’s throughput, the recording’s
framerate (FPS) may be reduced.
Record until
: You can use this setting to adjust how much free space
must remain when recording. It is suggested that you set this to at least
32M to allow for enough buffer space for the camera to record with.
When storage is full
: When your storage device is full or has reached
the free space limit specified in Record until, you can choose to stop
recording, or you can have the camera delete old recordings to free space
for new recordings to be saved.
Event Based
: Event based recording will allow you to record video when
specific events happen.
Motion detection triggered recording:
Enabling this option will set the
camera to record video when motion is detected by
the camera.
Prerecord
: This will set how many seconds of video before the event
takes place will be recorded.
Postrecord
: This will set how many seconds of video after the event
takes place will be recorded.
Example:
Using motion detection triggered recording and setting Prerecord to 5 seconds and Postrecord to 9 seconds,
the camera will save video from 5 seconds before motion was detected to 9 seconds after motion was detected.
Continuous
: This will set the camera to record continuously.
Scheduled Recording
: This will set the camera to automatically record video during the specified times in the table
below.
After making any changes, click the
Save Settings
button to save your changes, or click the
Don’t Save Settings
button to discard your changes.
Summary of Contents for DCS-1130 - mydlink-enabled Wireless N Network Camera
Page 1: ......
