4
D-Link DCS-340 User Manual
Section 3 - Configuration
There is a button hidden in the pinhole beside the power socket. It is used to
reset
the system or
restore
the factory
default settings. Sometimes resetting the DCS-3420 will return the system back to a normal state. If the system still
has problems after reset, restore the factory settings and install again:
RESET
:
1. Lightly insert a paper clip (or a similar sized tool) into the reset hole on the back of the camera, press
lightly and then release the button.
2. The LED on the back of the camera will begin blinking red and green fast.
3. When the LED stops the blinking fast and starts blinking once every second, the reset is completed.
RESTORE
: 1. Insert the paper clip, or another similar tool, and press and continuously hold down the button
recessed inside the reset hole.
2. Wait for the LED on the back of the camera to blink red and green and hold the button through two
cycles of blinking (about 5-7 seconds.)
3. Withdraw the tool after the second cycle of the LED blinking and a factory restore has been
completed.
Reset and Restore
Reset Button
Note:
Restoring the factory defaults will result in the loss of any previous settings and will require running the IP Installer
to find the camera’s IP address.
