DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
The Spanning Tree Protocol will treat a link aggregation group as a single link, on the switch level. On the port level, the
STP will use the port parameters of the Master Port in the calculation of port cost and in determining the state of the link
aggregation group. If two redundant link aggregation groups are configured on the Switch, STP will block one entire
group, in the same way STP will block a single port that has a redundant link.
To configure port trunking, click
L2 Features > Trunking > Link Aggregation
to bring up the
Port Trunking Group
table:
Figure 7- 8. Port Trunking Group window
To configure port trunk groups, click the
Add
button to add a new trunk group and use the
Port Trunking Configuration
menu (see example below) to set up trunk groups. To modify a port trunk group, click the hyperlinked group number
corresponding to the entry you wish to alter. To delete a port trunk group, click the corresponding
under the
Delete
heading in the
Current Trunking Group Entries
table.
Figure 7- 9. Link Aggregation Group Configuration window – Add
82
