DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
Parameter
Description
Profile ID
This is the identifier number for this profile set.
Mode
Select
Permit
to specify that the Switch, according to any additional rule, forward the packets
that match the access profile added (see below).
Select
Deny
to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Rx Rate (No Limit:0)
Enter an Rx Rate in kbps.
Access ID (1-65535)
Type in a unique identifier number for this access. This value can be set from
1
to
65535
.
Auto Assign
– Checking this field will instruct the Switch to automatically assign an Access
ID for the rule being created.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content Mask.
Ethernet
instructs the Switch to examine the layer 2 part of each packet header.
IP
instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask
instructs the Switch to examine the packet header
Priority (0-7)
This parameter is specified if you want to re-write the 802.1p default priority previously set in
the Switch, which is used to determine the CoS queue to which packets are forwarded to.
Once this field is specified, packets accepted by the Switch that match this priority are
forwarded to the CoS queue specified previously by the user.
When
replace priority
is selected, the Switch will rewrite the 802.1p default priority of a packet
to the value entered into the priority field. This value will meet the criteria specified, before
being forwarded on to a specified CoS queue. Otherwise, a packet will have its incoming
802.1p user priority re-written to its original value before being forwarded by the Switch. The
replace priority
feature can only be used with DSCP value.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source IP
Enter an IP Address mask for the source IP address.
Destination IP
Enter an IP Address mask for the destination IP address.
DSCP (0-63)
This field allows the user to enter a DSCP value in the space provided, which will instruct the
Switch to examine the DiffServ Code part of each packet header and use this as the, or part
of the criterion for forwarding. The user may choose a value between
0
and
63
.
Protocol
This field allows the user to modify the protocol used to configure the Access Rule Table;
depending on which protocol the user has chosen, or configured in the Access Profile Table.
Port Number
Enter the switch port number(s) to which you wish this rule to apply.
Time Range
Enter the specific time range when this access rule will be implemented on the Switch.
To view the settings of a previously correctly configured rule, click
in the Access Rule Table to view the following window:
163
Summary of Contents for DES-3028
Page 306: ......
Page 307: ......
Page 327: ...D Link D Link D Link D Link 7 495 744 00 99 http www dlink ru e mail support dlink ru...
Page 332: ...Technical Support Web Web URL http www dlink jp com...
