DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
12
With the serial port properly connected to a management
computer, the following screen should be visible. If this screen
does not appear, try pressing Ctrl+R to refresh the console
screen.
Figure 1-1. Initial Console screen.
There is no initial username or password. Just press the
Enter
key twice to display the CLI input cursor
−
local>
.
This is the
command line where all commands are input.
Setting the Switch’s IP Address
Each Switch must be assigned its own IP Address, which is
used for communication with an SNMP network manager or
other TCP/IP application (for example BOOTP, TFTP). The
switch’s default IP address is 10.90.90.90. You can change the
default Switch IP address to meet the specification of your
networking address scheme.
Summary of Contents for DES-3250TG
