DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
130
config bandwidth_control
Syntax
config bandwidth_control <portlist> {rx
rate [no_limit/<value 1-1000>]/tx_rate
[no_limit/<value 1-1000>]}
Description
The config bandwidth_control
command is
used to configure bandwidth on a by-port
basis.
Parameters
<portlist>
−
Specifies a range of ports to be
configured. The port list is specified by
listing the beginning port number and the
highest port number of the range. The
beginning and end of the port list range are
separated by a dash. For example, 3 would
specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and
port 4
−
in numerical order.
rx_rate
−
Specifies that one of the
parameters below (no_limit or <value 1-
1000
>
) will be applied to the rate at which
the above specified ports will be allowed to
receive packets
no_limit
−
Specifies that there will be no
limit on the rate of packets received by
the above specified ports.
<value 1-1000>
−
Specifies the limit, in
Mbps, that the above ports will be
allowed to receive packets.
tx_rate
−
Specifies that one of the
parameters below (no_limit or <value 1-
1000
>
) will be applied to the rate at which
the above specified ports will be allowed to
Summary of Contents for DES-3250TG
