DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
148
config gvrp
Syntax
config gvrp [<portlist>/all] {state
[enabled/disabled]/ingress_checking
[enabled/disabled] }
Description
This command is used to configure the
Group VLAN Registration Protocol on the
switch. You can configure ingress checking
and the sending and receiving of GVRP
information.
Parameters
<portlist>
−
A range of ports for which you
want ingress checking. The port list is
specified by listing the beginning port
number and the highest port number of the
range. The beginning and end of the port
list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies
port 4. 3-4
specifies all of the ports
between port 3 and port 4
−
in numerical
order.
all
−
Specifies all of the ports on the
switch.
state [enabled/disabled]
−
Enabled or
disables GVRP for the ports specified in the
port list.
ingress_checking [enabled/disabled]
−
Enables or disables ingress checking for
the specified port list.
Restrictions
Only administrator-level users can issue
this command.
Summary of Contents for DES-3250TG
