DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
89
config stp
Purpose
Used to set up STP on the switch.
Syntax
config stp {ports <portlist> {cost <value
1-65535>/priority <value 0-255>/state
[enabled/disabled]} {maxage <value 6-
40>/hellotime <value 1-
10>/forwarddelay <value 4-30>/priority
<value 0-65535>/fbpdu
[enabled/disabled]}
Description
This command is used to set up the
Spanning Tree Protocol (STP) for the entire
switch.
Parameters
ports <portlist>
−
Specifies a range of ports
to be configured. Ports are specified by
entering the lowest port number in a group,
and then the highest port number in a
group, separated by a dash. So, a port
group including the switch ports 1, 2, and
3 would be entered as 1-3. Ports that are
not contained within a group are specified
by entering their port number, separated
by a comma. So, the port group 1-3 and
port 49 would be entered as 1-3, 49.
Additional ports can be individually entered
by their port number, separated by
commas. If you enter the ports sub-
command, you can enter the port STP cost,
priority, and state sub-commands listed
below.
cost <value 1-65535>
−
This defines a
metric that indicates the relative cost of
forwarding packets to the specified port
Summary of Contents for DES-3250TG
