DES-3350SR Layer 3 Fast Ethernet Switch User’s Guide
103
config stp ports
edge [true|false] – true designates the port
as an edge port. Edge ports cannot create
loops, however an edge port can lose edge
port status if a topology change creates a
potential for a loop. An edge port normally
should not receive BPDU packets. If a
BPDU packet is received it automatically
loses edge port status. False indicates the
port does not have edge port status.
p2p [true|false] – true indicates a point-to-
point (p2p) shared link. These are similar
to edge ports however they are restricted in
that a p2p port must operate in full-duplex.
Like edge ports, p2p ports transition to a
forwarding state rapidly thus benefiting
from RSTP.
state [enabled|disabled]
−
Allows STP to be
enabled or disabled for the ports specified
in the port list. The default is disabled.
Restrictions
Only administrator-level users can issue
this command.
Example Usage:
To config STP ports 5 to 10:
local>config stp ports 5-10 state enabled
Command: config stp ports 5-10 state enabled
Success.
local>
Summary of Contents for DES-3350SR
