DES-3350SR Layer 3 Fast Ethernet Switch User’s Guide
50
Example Usage:
To configure the speed of port 3 to be 10 Mbps, full
duplex, learning and state enabled:
local>
config ports 1-3 speed 10_full state enabled
Command: config ports 1-3 speed 10_full state enabled
Success.
show ports
Purpose
Used to display the current configuration of
a range of ports.
Syntax
show ports {<portlist|all>}
Description
This command is used to display the
current configuration of a range of ports.
Parameters
all
−
Displays all ports on the switch.
<portlist>
−
Specifies a range of ports to
be configured. The port list is specified by
listing the beginning port number and the
highest port number of the range. The
beginning and end of the port list range are
separated by a dash. For example, 3 would
specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and
port 4
−
in numerical order.
Restrictions none.
Summary of Contents for DES-3350SR
