D-Link DES-3350SR Standalone Layer 3 Switch
96
Src Protocol
Allows for the selection of the protocol for
the source device. Choose between
RIP
,
OSPF, Static
and
Local
.
Type
Allows for the selection of one of six
methods of calculating the metric value.
The user may choose between
All
,
Internal
,
External
,
ExtType1
,
ExtType2
,
Inter-E1
,
Inter-E2
. See the table above
for available metric value types for each
source protocol.
Metric
Allows the entry of an OSPF interface
cost. This is analogous to a Hop Count in
the RIP routing protocol. The user may
specify a cost between 0 and 16.
Click
Apply
to implement changes made.
NOTE: The source protocol (Src Protocol) entry and the destination
protocol (Dest Protocol) entry cannot be the same.
Static/Default Route Settings
Entries into the Switch’s forwarding table can be made using both MAC addresses and IP addresses. Static IP forwarding is
accomplished by the entry of an IP address into the Switch’s Static IP Routing Table. To view the following window, click
Configuration > Layer 3 IP Networking > Static/Default Route Settings.
Figure 9 - 7. Static/Default Route Settings window
This window shows the following values:
Parameters Description
IP Address
The IP address of the Static/Default
Route.
Subnet Mask
The corresponding Subnet Mask of the
IP address entered into the table.
Gateway
The corresponding Gateway of the IP
address entered into the table.
Cost (1-65535)
Represents the metric value of the IP
interface entered into the table. This field
may read a number between 1-65535 for
an OSPF setting, and 1-16 for a RIP
setting.
Protocol
Represents the protocol used for the
Routing Table entry of the IP interface.
This field may read OSPF, RIP, Static or
Local.
Backup State
Represents the Backup state that this IP
interface is configured for. This field may
read Primary or Backup.
Delete
Click the
if you would like to delete
this entry from the Static/Default Route
Settings table.
Summary of Contents for DES-3350SR
