![background image](http://html1.mh-extra.com/html/d-link/des-3350sr/des-3350sr_user-manual_3345491053.webp)
D-Link DES-3350SR Standalone Layer 3 Switch
43
Current Time Settings
To enable
SNTP
on the Switch, click
SNTP Settings
in the
Configuration
folder and then click
Current Time Settings
:
Figure 7 - 24. Current Time window
To use SNTP, toggle the SNTP State in the Current Time: SNTP Settings section to
Enabled
and enter the IP address of the relay
the SNTP Primary Server and/or the SNTP Secondary Server. Enter an SNTP polling interval in the bottom field. The default
setting of 720 seconds is usually fine for most network configurations; a greater polling frequency will draw more network
resources. Click
Apply
to let your changes take effect.
To complete SNTP configuration, fill in the desired values in the Current Time: Set Current Time section and then click
Apply
.
Time Zone and DST
To make time zone and Daylight Savings Time changes to the SNTP configuration, click SNTP Settings in the Configuration
folder and then click Time Zone and DST:
Summary of Contents for DES-3350SR
