xStack
®
DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
236
Switch and will be filtered.
Select
Mirror
to specify that packets that match the access profile are mirrored to a port
defined in the config mirror port command. Port Mirroring must be enabled and a target port
must be set.
Priority (0-7)
Enter a priority value if you want to re-write the 802.1p default priority of a packet to the
value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
its incoming 802.1p user priority re-written to its original value before being forwarded by the
Switch.
Replace Priority
Enter a replace priority manually if you want to re-write the 802.1p default priority of a packet
to the value entered in the Priority field, which meets the criteria specified previously in this
command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have
its incoming 802.1p user priority re-written to its original value before being forwarded by the
Switch
Replace DSCP (0-63)
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
the selected criteria) with the value entered in the adjacent field.
Replace ToS
Precedence
Select this option to instruct the Switch to replace the Type of Service as part of the packet
header.
Rx Rate (1-15624)
Use this to limit Rx bandwidth for the profile being configured. This rate is implemented
using the following equation: 1 value = 64Kbit/sec. (ex. If the user selects an Rx rate of
10
then the ingress rate is 640Kbit/sec.) The user many select a value between
1
and
15624
or
tick the No Limit check box. The default setting is No Limit.
Time Range Name
Tick the check box and enter the name of the Time Range settings that has been previously
configured in the
Time R ange
Settings
window. This will set specific times when this
access rule will be implemented on the Switch.
Counter
Enable or disable the counter settings.
Ports / VLAN Name /
VLAN ID
Use the pull down menu to select
Ports
,
VLAN Name
, or
VLAN ID
that the access rule will
take effect on, and enter a range of ports to be configured, or the VLAN name/ID of a
previously configured VLAN.
Click
Apply
to display the following Access Rule List window.
Figure 7 - 14 Access Rule List (IPv4)
To view the configurations for previously configured rule click on the corresponding
Show Details
Button which will
display the following
Access Rule Details
window.
Figure 7 - 15 Access Rule Detail Information
Summary of Contents for DES-3528 - xStack Switch - Stackable
Page 19: ...xStack DES 3528 DES 3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual 18...
Page 214: ...xStack DES 3528 DES 3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual 213...
Page 306: ...xStack DES 3528 DES 3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual 305...
