DFE-660TX Fast Ethernet PC Card User's Guide
Hardware Installation
9
It is most usual for the lower one of the two slots in the stack
to be designated Slot 1, but there are exceptions. In the
subsequent procedure for DFE-660TX software installation,
it might be useful for you to know whether your DFE-660TX
is installed in Slot 1 or Slot 2. Under Windows 95, you can
check by opening the Control Panel / PC Card display.
Under DOS it is also possible to make a software check, but
it is more difficult. If it develops that you need to make a
trial-and-error determination or correction, then it is easy to
do: just reinstall the DFE-660TX in another slot.
Step 2 Attach the Media Coupler
The back-end receptacle of the DFE-660TX remains accessible
(approximately flush with the case of the computer) when the
DFE-660TX is properly seated in its PC Card slot. Taking care to
keep the top side of the media coupler plug up, insert the plug into
the DFE-660TX's receptacle until it is firmly seated and latched.
(The top side of the plug is labeled with a triangle molded into the
plastic.)
Keep the triangle mark on
top when you plug the media
coupler into the DFE-660TX
NOTE: When the media coupler plug is firmly seated, it is held in
place by small latching hooks at either side of the plug. To
avoid damage when detaching the plug from the
DFE-660TX, it is necessary to depress the latch wings of